How to install children's mountain bike

Open the box and check the accessories

Vehicle a front tire set a cushion cushion tube a set of mudboard a pair of guard wheel a pair

One accessory box (pedal, headlight, wheel guard, wheel guard card, handlebar stand, sponge cushion for the head)

Ii. Start assembly

1. Remove the rear axle nut with a wrench to install the guard wheel, and thread the guard wheel and the guard wheel fixing piece together. Note that the guard wheel fixing piece can be divided into left and right sides, L on the left and R on the right.

Combine the plastic wheel, clip and cover on the other end.

2. Load the handlebar, fix the riser and the horizontal pipe with the inner hexagon wrench, as shown in the figure, pay attention to the riser with a safety line, the height should not be higher than the safety line, be sure not to expose the safety line outside, to be buried in the pipe.

3, install the front wheel, pay attention to the front axle has a heterosexual with hook gasket, be sure to hook the fork of the small hole.

4, adjust the brake line into the brake handle, through the slot, brake tube two ends to be fixed in the aluminum alloy groove, lock the screw on the brake clamp, pay attention to the line should be moderately loose, too loose can not brake, too tight brake will always hold the wheel.

5. Install front fender

Install rear fender seat

Finally, install the foot pedal, L is left, R is right