How to install:

Clearance adjustment, adjustment knob on handle, brake eating side, Angle, grip distance adjustment.

Clearance refers to the distance between pulling the brake lever and when the brake starts to take effect. If it is too large, the reaction will be slow, and if it is too small, it is not good, so you can adjust it until you feel comfortable pulling. As the brake skin wears, the clearance increases.

Adjustment steps: turn out counterclockwise, and remember to lock the fixing screw of the outer ring after adjusting. But can not turn to almost fast escape degree, so as not to fall off the risk.

You can pull the brakes tight, and then tighten the screws, less likely to run away. If the brake will make a sound, you can adjust it to a figure eight, that is, the gap between the rear side and the rim of the wheel is about 1mm. Find a cushion, tighten the brakes, and lock them.

Angle adjustment of brake lever: loosen the screw on the handle, but the handle of this car is quick disassembly and adjustable, so there is no need to move the screw; Correct - to maintain the extension line in the arm; Error → level loading, wrist will be uncomfortable.